5th Gen Camaro Console shifter bezel ?

[srode]

Is there a difference in the hold size and or location of the shifter bezel in a 5th Gen Camaro console between manual and automatic? Are they interchangeable? Not worried about the gauges, just the cover bezel hole

[CapSS92]

Looks like they might be slightly off. Check this out...

https://www.camaro5.com/forums/showthread.php?t=281146

https://www.ebay.com/itm/12627282146...temCondition=4

https://www.ebay.com/itm/14557348252...temCondition=4

[srode]

Looks like they might be slightly off. Check this out...

https://www.camaro5.com/forums/showthread.php?t=281146

https://www.ebay.com/itm/12627282146...temCondition=4

https://www.ebay.com/itm/14557348252...temCondition=4

Thanks, looks like minor differences like you said. For a retrofit in a first gen manual transmission it doesn't look like that difference would matter.

[boss_hoss]

They are different. I put a manual shifter boot on an automatic bezel and it fits but there’s about a 1/8” gap towards the dash end. You can dreamel the tabs that mount the shifter boot ring to the console though to make it work.

[boss_hoss]

Here’s the gap

[srode]

Here’s the gap

Looks good, where did you find the shifter boot and ring?

[boss_hoss]

I think I got the 2010-15 Camaro shifter boot from eBay or Amazon and then the ring is from Lokar. The lokar ring and the plastic bit at the top of the camaro boot snap together pretty nicely with a bit of massaging.

https://www.speedwaymotors.com/Lokar...iycX57ucRHpftc